Build Progress

[Sotnax]

Just an update here:

Re-designs have been submitted to the library. Should be done later this week.

I am currently editing part 3 of the build guide: Threaded Inserts.

[Sotnax]

Build Guide Part 3



Part 3 is up!

Part three explains the steps to inserting the threaded inserts into the printed components of your Delta Throttle

As always, feedback is much appreciated.

https://youtu.be/5JVho1qHgS0

[Sotnax]

Question about programming

I am preparing to do my next video which will be a guide to the programming.

Does it matter if you have wired everything to the Pro Micro before or after programming it?

[zdayton]

Nope it doesn't matter. But make sure you use Arduino version 1.0.6. I just updated that in the build instructions.

[Sotnax]

Thanks!

[Sotnax]

Just to give an update, I am working on recording the programming of the Pro Micro.

This is not my area of skill so it is taking me quite a bit of trial and error.

My hope is to show a video that bypasses all the trials I am going through.

I'll update again in a few days

[zdayton]

Cool. If you have any questions feel free to post them!

[Sotnax]

Success!

After trying again today with a cooled temper I was able to get it working

I'll post here now what was happening:

Sparkfun tells you to place the add-on files in:
C, Users, user_name, Arduino, hardware, sparkfun, avr

But sparkfun was my problem. When I omitted sparkfun:
C, Users, user_name, Arduino, hardware, avr

Everything finally worked. Not sure why, but it did

Will begin editing the start to finish video guide of programming the Pro Micro shortly

[Sotnax]

@zdayton

Ok, so I have everything hooked up and the Pro Micro is programmed.

Is there a way to test that it is all working?

Also, how do I go about getting it to control my ship in Star Citizen?

Thanks!

[Sotnax]

So tinkering on my own and I found the feature that will test the controller in the Control Panel.

Looking into Star Citizen now